Tuesday, April 1, 2008

The dragonus II stock ESC speed controller programming manual

RCer BRUSHLESS MOTOR SPEED CONTROLLER ESC 35A-4S
(The following guide was taken from RCGroups.com. Thanks to Speed Stick 3D for this info)


ESC 35A + 3300KV Motor Combo


The ESC:

Technical specs:
  • Maximum load (in 30 seconds) 40A, for constant use: 35A
  • Working voltage: Li-ion / Li-polymer ----- 2 to 4 cell (6-15V) ; Ni-CD / Ni-MH ----- 6 to 12 cell (6-15V)
  • Working temperature: 0℃- 50℃
  • Maximum RPM: 2-pole motor / 210,000 rpm ; 6-pole motor / 70,000 rpm ; 12-pole motor / 35,000 rpm

This is a Galaxy ESC, Best for Helicopter & High-C ratio Li-Poly

The soft start program is designed for all helicopter users.
“Galaxy ” will play a music when all the setting is ready to go, so all users do not
need to worry about whether their speed controller is ready to go or not when the power been connected.
Please read the following instruction and warning before you start using “Galaxy ” speed controller.

1 “Galaxy ” is suitable for:
Ni-CD/Ni-MH 6 ~ 12 cell
Li-ion/ Li-Polymer 2 ~ 4 cell
※warning: when using Ni-CD/NiMH 11~12 cell or Li-ion/Li-Polymer 4 cell. The maximum discharge current DO NOT over 12A and 180W.

2. “Galaxy ” has programmed for soft start.

3. When battery voltage drops to the pre-set (60%) level (could be set at 50%), the motor output decreased gradually instead of a sudden-stop. This low battery warning function allows an early safe landing on R/C aircraft.

4. It has start and over Heart protection function.

5. Automatic Throttle adjustment for using on every transmitter.

6. Brake or Non-brake.

7. selectable “ready to go” melody. (need select by RCER program card)

8. “Galaxy ” has program card setting or manual setting function.

9. The program can be upgrade when there is new program available. (need contact RCER or your local dealer)

10. The motor will decrease its power to full stop if the receiver is out of the control range. Back to the receiving range the motor power will be resumed.
In field use, switch-on the transmitter and always make sure that the throttle is on the low end before connecting the battery. The controller will detect battery voltage once the battery is connected.

Instructions:

1. Manual setting:
A. Throttle curve setting: move the throttle stick to the top point, than connect battery to
“Galaxy ”, 2 short “B-B” will be heard, then by removing the stick to the low end. When the setting is ready a melody will be heard.
B. Non-Brake setting: switch on transmitter and moving the stick to the top end then connect the battery to “Galaxy ”. Wait until a 3 “B-B-B” be heard, removing the stick to the low end.
When the setting is ready a melody will be heard.
C. Brake setting: switch on the transmitter and move the stick to the top end. Connect battery to
ESC. Wait until 4 short “B-B-B-B” be heard then by removing the stick to the low end. When the setting is ready a melody will be heard.
2. Program card setting: setting up by RCER program card. (for more detail please read the program card instruction)

No comments:

Post a Comment

Popular Posts